Argos MDT-10DMN3 Bedienerhandbuch Seite 6

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 12
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 5
5
OPERATION
Whe
n
using the unit
When first using the dehumidifier, operate the unit continuously 24 hours.
O O
This unit is designed to operate with a working environment between 5 C and 35 C.
If th
e unit has been switched off and needs to be switched on again quickly, allow approximately
thre
e minutes for the correct operation to resume.
Do not connect the dehumidifier to a multiple socket outlet, which is also being used for other electrical appliances.
Select a suitabl
e location, making sure you have easy access to an electrical outlet.
Plug th
e unit into a 220~240V 50Hz(Refer to the nameplate located on the side/rear of the unit ) electrical
socket-outlet with earth connection.
Mak
e sure the water tank is correctly fitted otherwise the unit will not operate properly.
EMPTYING THE WATER TANK
1. Pull out the water tank a little.
2. Hold both sides of the water tank
with even strength, and pull it
out from the unit.
3. Pour the water out.
When the water tank is full, the unit will automatically stop
running, and the Full indicator light will illuminate.
Slowly pull out the water tank. Grip the left and right ha
ndles
securely, and carefully pull out straight so water does
not spill. Do not put the water tank on the floor because
the
bottom of the water tank is uneven. Otherwise the water ta
nk will
fall and cause the water to spill.
Discard the water and replace the water tank. The water ta
nk
must be in place and securely seated for the dehumidifie
r
to operate.
When the water tank is put back in its correct position, t
he
indicator light will go off and the unit will re-start.
NOTES:
When you remove the water tank, do not touch any parts
inside of the unit. It may damage the product.
Be sure to push the water tank gently all the way into the
unit.
Put the water tank back to the unit by force may damage the
unit or water tank.
- Do not remove the float from the water tank, the water tank
full sensor will no longer be able to detect the water level correctly
without the float and water may leak from the water tank.
Seitenansicht 5
1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare